Maintenance And Storage; Technical Parameters - LUND 67182 Manual Original

product with the battery and the batteries themselves by land. Additional conditions do not have to be met. If you entrust transport
to third parties (e.g. courier service), follow the regulations for the transport of hazardous goods. Before shipping, please contact
a qualifi ed person. It is forbidden to transport damaged batteries. During transport, the disassembled batteries should be removed
from the product, the exposed contacts should be secured, e.g. sealed with insulation tape. Protect the batteries in the packaging
in such a way that they do not move inside the packaging during transport. National regulations for the transport of hazardous
materials must also be observed.
Using the appliance
Before using the mop, adjust the extension's length so that the position when operating the mop is as inclined as possible. To
change the extension length, move and hold the lock button, and then change the extension length. After releasing the pressure
on the lock button, the length will be set to one of the positions closest to the desired length.
The mop has a water tank that allows the moistening of the cleaned surface in front of the head. Remove the tank's plug (V) before
pouring the water inside. Do not exceed the maximum tank capacity. When fi lling the tank, use pourers, funnels, etc. to reduce
water splashing risk. If water is splashed, wipe it thoroughly before starting work with the mop.
Warning! The tank should not be fi lled with a liquid other than clean, cold water. Do not add any other substances, e.g., detergents
or fragrances, to the water.
Place the mop on the fl oor and grab the handle. Slide the switch in the direction of the ON symbol. The mop will turn on, and the
display will show the battery charging status.
The handle has two buttons. The switch starts the discs spinning, and the button marked with the water drop symbol allows to
moisten the surface in front of the mop head.
Move the mop back and forth without applying too much pressure.
Pressing the switch on the handle again stops the discs spinning but does not turn off the mop. The appliance is turned off when
the switch is set to the OFF position.

MAINTENANCE AND STORAGE

CAUTION! Never immerse the appliance in water or other liquids. This could cause electrocution and damage the product.
When cleaning is complete, turn off the appliance with the switch, remove the pads, and carry out their maintenance.
Clean the appliance with a slightly moistened cloth and then dry it with a dry cloth.
Do not use alcohol, solvents, acids, corrosive or abrasive agents for cleaning.
The microfi bre pads can be washed in a washing machine at temperatures up to 40
fabrics. Do not bleach, do not iron, do not tumble dry. After washing, spread fl at and leave to dry completely.
The pads wear out during use. If signs of wear, such as irremovable dirt, fi bre loss, or abrasion are observed, replace the pads
with new ones. The pads must also be changed if they got damaged during cleaning. It is forbidden to use the mop if its pads are
damaged. The appliance can be used with the LUND 67183 pads.
The appliance can be stored in a vertical position. Store the appliance disconnected from the charger.

TECHNICAL PARAMETERS

Parameter
Catalogue No.
Rated voltage
Type of battery applied
Battery capacity
Battery energy
IEC protection class
Water tank capacity
Weight
Charger
Supply voltage
Rated frequency
Rated current
Output voltage
Output current
IEC protection class
O R I G I N A L
GB
C, using a programme designed for synthetic
O
Unit
[V DC]
[mAh]
[Wh]
[ml]
[kg]
[V~]
[Hz]
[A]
[V DC]
[A]
I N S T R U C T I O N S
Value
67182
7.4
Li-ION
2000
14.8
III
200
1.45
100 - 240
50/60
0.3
9
0.5
II
11