Features; Assembly - RIDGID R8699 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
LEDs ...................................... 35 Watts Total (5 Watts/LED)
Light Output ......................... 3,200 / 2,000 / 1,000 Lumens

ASSEMBLY

WARNING:
Do not use this product if it is not completely as-
sembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
OPERATION
WARNING:
Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam
may result in serious injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not recom-
mended can result in serious personal injury.
NOTICE:
Operate in a well ventilated area. Do not block
vents. Keep them clear to allow proper ventilation.
Maximum Runtime ............................................... 8.5 hours
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 To illuminate distant objects and areas requiring additional
light
INSTALLING/REMOVING BELT HOOK (NOT
INCLUDED)
See Figure 1, page 7.
The belt hook is interchangeable. It may be installed on
either side of the base.
 Align hole in belt hook with hole in tool's base.
 Install screw to secure belt hook in place.
 To uninstall, remove screw and then belt hook.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 7.
 Align the raised rib on the battery pack with the groove
inside the spotlight, then slide the battery pack into the
light.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
4 - English