Test The Machine Before First Use - Grube RJ12 Manual Del Propietário

Installation
1 . Remove the transportation lock (A) and the
cable ties (B) that hold the grinding head in
place .
B
A
2 . Remove the grinding wheel guard (C) to
access the wheel attachment nut (B) . Turn
the two attachment knobs (D) to remove
the guard .
A
3 . Remove the wheel attachment nut from
the grinding motor .
16 RJ12_v1_EN_220223
4 .
5 .
6 .
7 .
8 .
D
C

4 .6 Test the machine before first use

1 .
B
2 .
3 .
4 .
5 .
Next, insert the appropriate wheel onto the
grinding motor and, using moderate pressure
with your hands, secure the wheel attachment
nut to hold the wheel in place .
WARNING Over-tightening the wheel can
cause it to break .
Finally, reposition the guard and secure it in
place with the knobs .
WARNING Never start the grinder without
the wheel guards in place .
Before using the grinder, you'll need to check to
ensure the wheel is properly installed .
With the power off, gently spin the grinding
wheel and check for wheel wobble .
Conduct a final check for proper assembly by
turning on the main power and switching on the
wheel power switch while standing to the side .
Look for vibrations due to wheel oscillation or
other interference .
WARNING Always keep bystanders at a
safe distance from a grinder while in operation .
Note: To get the best performance from your
grinder, ensure the grinding wheel is centered
over the vise . Refer to this user manual or the
provided video for specific instructions .
Make sure that all packing materials are
removed .
Make sure that the wires and when used with a
stand, air hoses are correctly connected .
Make sure that the machine is securely
mounted .
Make sure that the machine is on a level
surface .
Perform a sharpening test on the machine to
ensure it functions correctly . See section 7 .2,
"Sharpening test"
RJ12