Technical Specifications - VONROC CR506AC Traducción Del Manual Original

TECHNICAL SPECIFICATIONS

Model No.
Compressor type
Compressor drive
Voltage
Frequency
Input power
Horsepower
Operating mode
Idling speed
IP class
Protection class
Air intake
Output (compressed air) at 7 bar
Output (compressed air) at 4 bar
Max. outlet pressure
Cut-in pressure approx.
Cut-out pressure approx.
Tank capacity
Cable length
Weight
Sound pressure level
Sound power level
* S3 = intermittent operation without the impact of
the start-up. This means that during a period of 10
minutes, the maximum operating time is 50% (e.g.
5 minutes of work and 5 minutes of rest) , under
optimal environmental conditions (max. temp
25°C). Respecting these guidelines and the prescri-
bed maintenance intervals will allow the product to
work properly over time.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Cover
2. Switch
WWW.VONROC.COM
3. Pressure switch
4. Pressure regulator
CR506AC /
5. Quick coupler (outlet)
CR506AC_GREY /
6. Pressure gauge (operating pressure)
CR506AC_WHITE
7. Pressure gauge (tank pressure)
Piston - oil free -
8. Safety valve
low noise
9. Handle
10. Pressure pipe
Direct drive
11. Drain cock
220-240V~
12. Air inlet
50 Hz
13. Air filter
14. Overload switch
750W
15. Tank
1 HP
16. Rubber feet
S3 50% *
17. Bolts
18. Washers
1450/min
19. Nuts (for feet)
IP30
20. Wheels
Class I
21. Axle bolts
22. Lock washers
128 l/min
23. Nuts (for wheels)
42 l/min
24. Allen screws
65 l/min
3. ASSEMBLY
8 bar
6 bar
8 bar
24L
2m
Mounting the wheels (Fig. A, B)
23 kg
1. Insert the wheel axle bolt (21) into the intended
L = 79.7 dB(A)
pA
K = 3 dB(A)
2. Mount the wheel (20) on one side of the tank
pA
L = 92.7 dB(A)
WA
K = 3 dB(A)
WA
3. Tighten the nut (23) by using a wrench.
4. Repeat these steps for the other wheel (20) on
Assembling the rubber feet (Fig. A, C)
1. Insert the bolt (17) into the intended hole of the
2. Insert the bolt (17) into the intended hole of the
3. Mount the rubber foot (16) on one of the two
4. Tighten the nut (19) by using a wrench.
5. Repeat these steps for the other foot (16) on
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
hole of the wheel (20).
(15). Using the supplied lock washer (22) and
nut (23) as shown on figure B.
the other side of the tank (15).
washer (18).
rubber foot (16).
mounting points on the bottom of the tank (15)
as shown on figure C.
the other mounting point.
EN
7