Technical Specifications; Machine Information - VONROC CH515AC Traducción Del Manual Original

• When the machine is not used for a long time,
unplug the machine form its means. Pull by the
plug, never remove the plug by pulling the cord.
• Keep the machine far from curtain or places
where the air inlet van easily be blocked.
• In order to prevent possible electric shock or
leakage current, never use the machine with
wet hand or operate the machine when there is
water on the power cord.
• Do not dispose of electrical appliances as
unsorted municipal waste, use separate
collection facilities. Contact your local
government for information regarding the
collection systems available. If electrical
appliance are disposed of in landfills or
dumps, hazardous substances can leak into
the groundwater and get into the food chain,
damaging your health and well-being.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions. Always check
that the voltage of the power supply corresponds
to the voltage on the rating plate label.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.

2. MACHINE INFORMATION

Intended use
The convector heater is intended for indoor use
only. The machine must be placed on a stable
surface. The heater is equipped with a thermostat
and safety features such as over-heat protection.
WWW.VONROC.COM

TECHNICAL SPECIFICATIONS

Model No.
Power supply
Power rating
Heater settings
Protection class
DESCRIPTION
The numbers in the text below refer to the numbers
used in figures A, B on page 2.
1. Convector heater
2. Heating knob
3. Thermostat knob
4. Floor stand
3. OPERATION
Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you
may notice a slight smell originating from the
heating element. This is quite normal and it should
disappear after using the heater for some time.
Placing the convector panel heater on the floor
(fig. C)
• Install the floor stands (4) on the underside of
the heater (1) using the supplied screws (fig. C).
• Place the heater upright on a firm and level
surface.
• Keep a minimum distance of 1m from
combustible materials (furniture, curtains, etc.).
Keep away from wet environments.
Warning! Make sure to place the heater in
a safe spot, so you cannot easily trip over
the machine and cable. Make sure to place
the heater where it cannot fall down.
EN
CH515AC
CH515AC_GREY
CH515AC_WHITE
220-240V~ / 50Hz
1800-2000W
1250W / 2000W
Class I
5