Refco OCTA-WIRELESS-CB Manual De Instrucciones página 3

4. Turn on the transmitter of the platform
The LED light on the transmitter flashes and sends the ID code within 2-3 seconds.
The control box reads the ID code of the transmitter and shows it on the display
(Ex. ).
295
SET
5. Press the
setting mode.
6. Perform factory calibration:
See OCTA-WIRELESS user manual
Caution:
The ID setting must be performed 1:1 (one platform to one control box).
Ensure that there is no interference when completing the ID setting.
If the control box does not receive and display the ID code sent by the
transmitter (within 2-3 seconds):
Restart the transmitter.
button to confirm. The display reads
888.88.8
and ends the ID