CARE & MAINTENANCE
OVEN LIGHT REPLACEMENT
Important: Before replacing the oven light bulb,
make sure the electrical power is disconnected from
the appliance. Failure to do so may result in electric
shock or burn.
Be sure to let the light cover and bulb cool
completely before replacing.
Removing the oven door can make this process
easier.
To replace the light bulb:
1. Remove the protective light cover. Do not remove
any screws to remove the light cover.
2. Do not touch the light bulb with a wet cloth.
Replace the light bulb with an appliance light
bulb suitable for high temperature and having
the same specifi cations: 230V, 60Hz, 25W, G9.
3. Replace the protective cover.
GLASS DOOR WINDOW
To clean the outside of the glass door window, use a
glass cleaner. Rinse and polish with a dry cloth.
Avoid scratching or impacting the glass window.
Doing so may cause the glass to break.
DRIP TRAY
There is a drip tray located in the bottom of the
oven that should be cleaned regularly.
Remove any solids with a scraper or paper towel.
Wash the drip tray with warm soapy water
and a soft cloth. Do not place the drip tray in a
dishwasher. Ensure the drip tray is completly dry
before replacing in the oven.
TROUBLESHOOTING
No power
• A fuse may be blown or the circuit breaker
tripped
• Plug not fully inserted into the wall outlet
• If the timer was previously used and the control
knobs were not returned to the "off" position, the
oven will not heat; return the knobs to the "off"
position, wait 30 seconds and then reset the
control knobs
Surface elements not working properly
• The elements are not properly installed
• The controls are not set correctly
Food does not broil properly
• Oven temperature is not properly set
• Shelf position is too low
• Cookware is not suited for broiling
• Aluminum foil is being used and is blocking air
fl ow
Food does not bake or roast properly
• Oven temperature is not properly set
• Shelf position is incorrect
• Oven was not pre-heated
• Cookware is not suited for baking or roasting
Oven light does not work
• Light bulb is loose
• Light switch is not operating correctly
21