CPI Gryphon Guia De Instalacion página 2

Installation
Before installation, remove the unit from packaging and ensure it arrived
safely. If it was damaged during shipping, go to
to locate a customer service contact near you.
1. Turn off the power to the vending machine.
2. Push the yellow button on the top right of the coin changer and tilt
the validator assembly forward to access the mounting holes. The
cassette does not need to be removed.
3. Hang the coin changer on the vending machine's mounting studs,
ensuring the unit is level. See the Alignment section.
4. The lower mount (a) can be difficult to see through the device.
Hanging the coin changer from the top 2 studs (b and c) first will
help to locate the lower mount.
5. Tighten screws, if necessary, being careful not to over-tighten.
Close the acceptor assembly. The lower mount is difficult to
access with a large screwdriver.
6. Remove the cassette. Lift it by the handle and pull toward you.
7. Fill the cassette with coins, ensuring the coins are inserted into
the proper tubes.
8. Return the filled cassette to the coin changer
correctly seated.
9. Connect the interface cable. For note validators, connect the
interface cable from the coin changer to the note validator's Y
connector (below).
To machine
10. Use cable ties to secure any excess cabling inside the vending
machine, ensuring that the cables do not interfere with the
vending machine or coin changer operation.
11. Restore power to the vending machine.
Alignment
After installation, ensure there is a small gap (a) of 2-4mm
(0.08-0.16 inches) between the lever on the vending machine (b) and
CranePI.com/Support
the return lever on the coin
– Press the coin return lever on the machine door. Confirm that
it fully opens the validator lid (d) on the coin changer, and then
smoothly returns and fully closes.
– Check alignment between the coin input chute and the coin cup,
ensuring it does not impede operation of the validator lid.
– Check alignment between the base of the coin changer, payout
area, and cashbox entry.
– Align, adjust, and test as necessary to ensure coins are properly
routed before continuing.
mmi interface
Final setup and configuration is guided with the MMI screen, A - F keys
and the center MENU KEY (
and ensure it is
From note validator
To coin mechanism
changer (c).
≡
).
mmi interface - continued
The MMI updates its interface as needed in each section. Always use
the on-screen guidance, but when in doubt, this chart lists general
sub-menu navigation tips.
Navigation Key
Scroll up D
Scroll down E
Move left A
Move right B
Next page F
Previous page C
≡
Display previous menu level
Press
≡
Return to the home screen
Hold for 3 seconds
Audit
≡
Press twice quickly (with the cassette in) to display audit
information. Each section will display for 3 seconds before showing
the amount of change in each tube.
par
Par to Level. Sets the coin level for each tube. Coins above that level
are sent to the cashbox.
Par to Value. Sets the fill level to a total cassette value. Once the value
is achieved, coins are sent to the cashbox. The unit
alters the individual coin levels to minimize the need for manual refills.
Par to Auto. The unit determines the optimal par level based on
actual coin usage.
once
dynamically
EN 2