Intellinet Network Solutions IPE-ODFE30 Manual De Instrucciones página 2

Instructions
This guide presents the basic steps
to set up and operate this device.
For specifications, visit support.intellinet-
network.com/barcode/561952.
Register your product at register.
intellinet-network.com/r/561952 or
scan the QR code on the cover.
Connections
Device Connections
Note: Your needs and setup may vary. Both
Extender units must be used together.
1 Plug a Cat5e/6 Ethernet cable — up
to 100 m long — from your powered
source device (for example, a PoE
injector or switch) into the Output
connector on one extender.
2 Plug a second Cat5e/6 Ethernet
cable — up to 800 m long — from
the Input on the first extender to
the Input the second extender.
3 Plug a third Cat5e/6 Ethernet cable —
up to 100 m long — from the Output
on the second extender to the device
you want to transmit power and data
to (e.g., a PoE network camera).
Cable Connections
Follow these general steps to make
waterproof connections on all cables that
connect to the units. Use a wrench to ensure
tight connections and whenever necessary.
2 English
1 Unscrew the Nut from the Body.
2 Loosen the washer and unscrew the Body
from the unit.
3 Remove the Insert from the Body and feed
the cable through the Nut and Body.
Replace the Insert into the Body .
4 Install the cable plug into the port. Screw
on the Body to the unit.
5 Tighten the Body washer to the unit.
6 Tighten the Nut to the Body.
Body
Nut Insert
with
washer