Do not expose the device to splashing or dripping water.
Vessels filled with liquids (vases, glasses or similar) must not be placed on the device or near it. There is a
risk that the container will tip over and the liquid will affect the electrical safety.
It is normal that during the use the device produces heat. Do not completely cover the product during use
to avoid overheating.
Damage!
Keep the device away from any type of moisture and avoid dust, heat and direct sunlight.
Do not use water or chemical solutions to clean the device. Only use a dry cloth for this purpose.
Do not open the housing of the device and do not disassemble it into its component parts. Do not try to
repair it yourself. The guarantee expires in this case.
Avoid hard impacts to the device.
Operate the adapter only on earthed sockets with AC 100-240V~, 50/60 Hz. If the power supply is not safe
at the installation site, ask the competent power supplier.
To interrupt the power supply of your device, disconnect the power supply from the power socket. When
disconnecting, always hold the adapter. Never pull the cable.
Declaration of conformity
The CE marking says that this product meets the requirements of all EU Directives applicable
for this product.
The UKCA marking says, that this product meets the requirements of all UK Directives applicable
for this product.
Simplified declaration of conformity
Intenso International hereby declares that the Wireless Charger MB13 complies with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following internet address:
www.intenso.eu.
SCOPE OF DELIVERY
Intenso Magnetic Wireless Charger MB13
1
Power supply HP8
3
Please check whether the packaging contents (see also diagram at the beginning of the manual) are com-
plete and undamaged. If this is not the case, please contact the seller or our service department:
rma@intenso-international.de
1.5 meter USB-C to USB-C cable
2
Operating instructions
4
EN - Page 3 of 6