Translation Of The Original User Manual - Novus Attenzia space Manual De Instrucciones

en Translation of the original user
manual
Key to pictograms
1.1 Key to pictograms
ATTENTION
Important information
Read operating instructions/
safety instructions.
Technical data
How to use
CAUTION!
Risk of electric shock.
Disconnect device from the power supply.
The power plug is used to disconnect the
power supply.
Connect device to the power supply.
The mains connection must conform to the
light's specifications!
Compliance with the relevant EU safety dir-
ectives
The certification attests that the product
complies with the device and product safety
legislation.
Protection class I
Operation with protective earth conductor
connection
ON/OFF
Press multifunction button briefly once
Set setpoint value
Press multifunction button briefly twice
Dim
Press and hold down multifunction button
Minimum brightness setting
Maximum brightness setting
Selected brightness setting
Brightness setting saved.
Light lights up twice.
Colour temperature
to be set by touch
Biorhythm
The product must only be installed and op-
erated in dry, enclosed interior spaces.
1.2 Line break
1.3 Attention
Carefully read through the operating in-
structions and safety instructions before
putting the product into operation.
You must follow the instructions! Keep the
operating instructions in a safe place ready
for later reference.
Subject to technical modifications.
Intended use
1.4 Intended use Warranty
This light is designed for private use and for use in a
normal office environment.
Only the original Novus carrying elements approved
for the light may be fastened.
The light must only be used with a designated
original Novus mount!
Wear and damage due to improper use or unauthor-
ised modifications and repairs are not covered by
the warranty or the guarantee.
Safety instructions
1.5 Safety instructions
You must observe the following instructions:
– Risk of eye damage! Never look directly into the
light source!
– The mains voltage and frequency of your power
supply must match the specifications on the
nameplate of the light. Ensure that the light can be
disconnected from the power supply at any time.
– Only use the light with the supplied connection
cable. The mains socket must be easily access-
ible at all times.
– Only use the light if it is in perfect condition. Ob-
serve the operating instructions, the usual regula-
tions and guidelines, and the applicable safety
and accident prevention regulations.
– If the light malfunctions, immediately disconnect it
from the mains by pulling the plug.
– If the outer flexible cable for this light is damaged,
it must only be replaced with a cable which is
available exclusively from the manufacturer or the
manufacturer's service representative.
– Only operate the light in enclosed spaces at tem-
peratures of 15 °C to 32 °C (59 °F to 90 °F) and a
non-condensing humidity of 15% to 95%.
– Do not use the light in rooms where there is a risk
of explosion.
9