BABYTREND SMART STEPS WK03XXXA Manual De Instrucciones página 7

ASSEMBLY
TOY ATTACHMENT
•
5 Place toys in this order
as shown. Toys must be
properly attached before
use (Fig. 5a).
NOTE: ONLY the rattle
and the rocket toys are
interchangable.
• All toys must be aligned
with their single or double
tab housings on the activity
center tray (Fig. 5b). Set the
toy base in alignment with
the tabletop fitting. From
underneath the tabletop
push the lock up and turn it
left to lock.
• Use the diagram below
(Fig. 5c) to lock the toys
onto the tabletop. (1) Push
the tab up and rotate it left
to lock. (2) Rotate the tab
right to release the toy. (3)
Always put the small tab
lock back into the tabletop
when not in use.
Align
1
2
11
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 5a
Fig. 5b
Align
3
Fig. 5c
HEIGHT POSITIONS
IMPORTANT: Never change the
height when the baby is in the
walker.
6
• To adjust the height
position(s), push the button
on the table leg to the
desired position. Repeat
for the other sides.
NOTE: Each leg has 3
adjustable height levels.
ALWAYS adjust all 3 legs
to the same level (Fig. 6).
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
ASSEMBLY
Fig. 6
12