Ninja NC300EU Guia De Inicio Rapido página 8

2) Display Guide
One-Touch Programs
Each program is intelligently designed to whip up
delicious creations in 1 to 2 1 / minutes. Programs
2
vary in length and speed depending on the
optimal settings to get perfectly creamy results
for that type of recipe.
When the program is running, the paddle
will move down through a frozen base
and return back to the top to create
chef-approved treats.
INSTALL LIGHT
A
Blinking light – Indicates the bowl
is not properly installed.
Solid Light – Indicates the paddle
is not installed correctly.
B PROGRESS BAR
Indicates progress of the program
selected. When a program is finished,
all 4 segments will flash twice and then
turn off.
PRE-SET PROGRAMS
C
Select the program that suits your recipe
and the paddle will process the base to
create the ideal texture in 1 – 21/2 minutes.
When you're ready to get started refer to
the recipe guide for ideas of what you can
make with each program.
A B
C
D
E F
EXTRAS
D
Use after you've processed your dessert
to EXTRAS extras like chocolate chips,
nuts or sweets.
E POWER BUTTON
Use to turn unit on and off.
F RE-SPIN
Useful if the base looks crumbly after
running a program. This can happen
if the base is really cold.
Do not RE-SPIN if using EXTRAS.
Refer to the recipe guide for more
detailed information on each function.
3) Assembly
1.
Plug in unit
Make sure to plug in Remove lid from tub
the unit before assembly and check that the
and switch Power on ingredients in the tub
The unit will NOT recognise
have not been frozen
the outer bowl and therefore
at an angle. Place
will not work if it is installed
the tub containing
before the unit is plugged in.
the frozen base in
the outer bowl.
4.
Install lid
Position the tab of the
lid just slightly to the right
of the outer bowl handle
so the lines on the lid and
handle align. Rotate the
lid clockwise to lock.
2. 3.
Install tub Install paddle
Press and hold the paddle latch
on the top of the outer bowl
lid, then insert the paddle in
the bottom of the lid. Release
the latch to secure the paddle.
Latch will be in the centre when
the paddle is correctly installed.
The paddle will feel loose
when installed. Turn the lid
upside down or give the
paddle a spin to be sure
it is secured.
5.
Install outer bowl
After plugging in the unit, place the
outer bowl on the motor base with
the handle in the middle of the unit.
Twist handle to the right to raise the
platform and lock the bowl in place.
You will hear a click when the
bowl is correctly installed.