Bticino T9654A Manual De Instalación página 7

Description
The camera uses a reliable and long-life 1/4" solid state
CCD colour detector.
It offers excellent picture play back and high heat resi-
stance.
A- 12Vd.c. power supply connector
B- BNC connector (VIDEO OUT)
Connections
Connect the camera (Video Out) output to the monitor input terminal
(Video In) using a coax cable (75 ohm).
Supply the camera with 12V d.c. ± 10%
- recommended power supply BTicino Item 392100.
Features
Power supply
Absorption
Detector
Resolution
Minimum lighting
Signal/noise ratio
Electronic shutter
White balancing
ALC
Output signal
Optics mounted
Lens
Dimensions (mm)
Weight
Note
: drawings and specifications are subject to change without notice.
Warnings
- Do not turn the camera towards the sun.
- Do not point the camera towards the sun even if it is not filming.
- Do not film when the light is too bright.
- Install the camera in a place where it cannot get wet. If it gets wet, detach it from the power supply immediately and contact the
after-sales service.
- Install the camera away from video noise sources. When the camera cables are laid near to electrical conductors or antennae
for televisions, there may be interference on the picture. If this happens, reposition the cables or reinstall the device.
- The picture quality may be worsened or some parts inside the camera may be subject to faults, if the ambient temperature is
higher or lower than that indicated in the specifications. The camera should not be used in these circumstances.
- Precautions should also be taken if there is a high degree of humidity.
12V d.c. ± 10%
80mA
1/4" colour CCD
512 (H) x 491 (V) NTSC // 512 (H) x 581 (V) PAL
1 lux /F 2.0
> 48dB (AGC OFF)
1/60 (1/50) to 1/100.000 sec.
AUTO
3 windows
1,0Vpp composite - 75Ω
f3,6mm/F2.0
angle 70°
87 x 26mm
305g
87mm
A
B
A
+
B
GB
7
4,5mm
-