PNI SafeHome PT802P Manual De Usuario página 7

Set the device to pairing mode
• Move the switch from the Compatible position to the
Quick position and wait 10 seconds.
• Move the switch from the Quick position to the
Compatible position again.
• The red LED starts to flash rapidly, which confirms that
the product has been reset and is entering pairing mode.
The mating mode has a limited time period. Repeat the
procedure if time runs out.
Reset/ disconnect/ delete
• Move the switch from the Compatible position to the
Quick position and wait 10 seconds.
• Move the switch from the Quick position to the
Compatible position again.
• The red LED starts to flash rapidly, which confirms that
the product has been reset and is entering pairing mode..
This procedure also deletes the product from the Tuya
application.
7 User manual