Craftsman CMXMSAJ94773 Manual De Instrucciones página 6

English
3. Using the methods listed above, install another
crossbeam to the opposite side of the upright frames,
parallel to the first crossbeam you installed. Make sure
both crossbeams are at the same level.
4. Repeat steps 1-3 for each set of crossbeams that you
wish to install. (Fig. G)
Fig. E
4
Fig. F
1
4
Fig. G
Shelf Support and Safety Strap
Instructions (Fig. H, I, J)
1. Each set of crossbeams
(3) shelf support straps
6
straps installed.
2. Starting with the lowest set of crossbeams, place
a safety strap between the lower ridges of the
crossbeams where two sets of holes have been pre-
drilled. Thread a safety strap bolt
bottom of the pre-drilled holes and through the weld
nuts, and fully tighten with the included hex key
6
1
4
will need to have three
5
and two (2) safety
7
up through the
or drill bit. Repeat this process for the second strap for
this set of crossbeams. (Fig. H)
3. Repeat this process for the remaining three sets
of crossbeams. (Fig. H)
4. For each set of crossbeams, place a shelf support strap
perpendicular to the crossbeams, and insert each end
into the slots on each ridge of the crossbeams. (Fig. I, J)
Fig. H
Fig. I
Fig. J
14
4
7
6
4
5
5 6