Hisense LMS044M6RVE Manual Del Operador página 10

U
Lower hinge
Screw hole cover
Open the refrigerator door and remove all fittings inside the door.
Remove the upper hinge cover
Remove the two screws
on the right side of the cabinet top.
Carefully lift the door and place it on a padded surface to prevent scratching.
Remove the screw hole cover
of the unit. Be sure
Remove the two screws
Remove the bottom feet
Set the door into its new place making sure the pin enters the bushing at the lower frame section (hole).
Securetheupperhinge
upper frame section (hole).
Loosely secure the lower hinge
and do not tighten the bolts until the door is in the closed position and leveled.
Replace the upper hinge cover
Turn the door upright again.
Open the door and attach all fittings.
8
S
Special flange self-tapping screw
.
that connect the upper hinge
and transfer it to the uncovered hole on the right side
to press the button firmly into the hole.
that hold the lower hinge
and transfer it to the right side of the cabinet.
previously removed in step 5 on the left side of the unit. Make sure the pin enters the bushing on the
.
on the right side of the cabinet.
U
Bottom feet