JUNO JFX Serie Instrucciones De Instalación

JFX™ Series DMX 4-Channel Decoder
WARNING
: This DMX Decoder should only be powered by ACCUDRIVE
Use of non-ACCUDRIVE™ drivers may damage DMX decoder and void warranty. See Drivers & DMX Decoder
Spec sheet for more detailed information. Failure to follow instructions will void product warranty.
IMPORTANT SAFETY INSTRUCTIONS
•
Read all these instructions before starting installation.
•
Keep these instructions in a safe place for future reference.
•
Only qualified electricians in accordance with local codes should install these fixtures.
•
De-energize electrical circuit at circuit breaker prior to installation process. Always ensure power is
off before making any changes to installation.
•
Do not connect directly to high voltage power. Must be connected to approved Class 2 LED
driver.
•
Do not disassemble or modify these products beyond instructions or warranty will be voided.
•
Only install in an Indoor dry location.
•
Ensure wire gauge used from driver to decoder and decoder to LED strip is sufficient to maintain a
voltage drop under 3% (See Spec Sheet for details).
•
Maximum of 10x DMX Decoders may be connected via RJ45 DMX connection ports (DMX Output). DMX signal may be
extended further by installing a DMX 8-way splitter after the 10
SAVE THESE INSTRUCTIONS
Step 1. (DMX - System Installation)
Once mounting locations are determined for the LED driver junction box, DMX Decoder, and LED strips refer to DMX wiring
guide (Figure 1). CAT5 / RJ45 data cables are recommended for transmitting DMX-512 signal. XLR-3 cables may be
installed but require an additional adapter for connecting to DMX decoder.
Step 2a. (DMX - Standard Operation)
Adjust the following settings using the 3 buttons on the DMX start channel to adjust the
values of the DMX address. The decoder will control up to 512 channels (Figure 2).
a. To set the DMX address, press and hold 'button 1' for 2 seconds until numbers
on the display flash.
b. Select an address based on the functionality of the master DMX controller.
Once an address is selected, the remaining 3 channels will be utilized digitally.
Ex. If decoder is addressed to 001 on the display, then CH1- 001, CH2 – 002,
CH3 – 003, CH4 – 004.
c. Once display stops flashing, DMX address is set.
INSTALLATION INSTRUCTIONS
One Lithonia Way • Conyers, GA 30012 • (800) 705-SERV (7378) • www.acuitybrands.com
©2021 Acuity Brands Lighting, Inc.
TM
JFX Series Class 2, 24VDC Drivers.
th
DMX Decoder.
Rev. 04/22 P4915 1 of 6