Basic Operation; Initial Setup - Krüger & Matz KM0243FHD-S4 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22

BASIC OPERATION

1. Connect the device to power supply socket.
2. Connect the antenna cable into the appropriate RF input.
Switch the TV on and off
1. When the TV is connected to power supply, it will be turned on directly or be in
standby mode (red LED is on). If the TV is in standby mode, press the Power
button to turn it on.
2. To put the TV set into standby mode, press the Power button on the TV set or
remote control. The TV set remains on, but with low energy consumption. To
switch off the TV set, unplug it from power supply.
Note: For some models, press Power button to switch off the TV set.

INITIAL SETUP

The first time you switch the TV set on, the Welcome screen appears, which guides
you through the initial setup process. Follow the on-screen instructions to finish the
initial setup process such as selecting the language, connecting to the network,
scanning channels and more. During each step, either make a choice or skip the
step. If you skip a step, you can perform the setup later from the settings menu.
LOCK CODE
To enable lock function, input default code 1234. Default code should be changed in
the lock menu. If you forget existing code, input code 0423 to access the lock menu.
20
Owner's manual

Publicidad

Tabla de contenido
loading

Tabla de contenido