Cleaning The Brush - POLTI FORZASPIRA D-POWER SR550 Manual De Instrucciones

Rinse the tank filter using running water
only and shake gently to remove any excess
dirt or water residue. Before replacing the
filter in the appliance, leave to dry natural-
ly, away from sources of heat, for at least
24 hours.
- Replace everything by performing these
steps in reverse order.
ATTENTION: Check that all dust collector
components are dry before reassembling
them.
7.2 CLEANING THE TOP FILTER
- Remove the top filter cover by rotating it an-
ti-clockwise (23).
- Remove the top filter cover (24) and rinse it
with running water only and shake gently to
remove any remaining dirt or excess water.
Before replacing the filter in the appliance,
allow it to dry naturally for at least 24 hours
away from heat sources.
- Replace everything by performing these
steps in reverse order.
The filters should be fully cleaned approxi-
mately every four months.
ATTENTION: Do not clean the filters with
the brush, as they can be damaged, thereby
reducing the filtering capacity. Do not use
detergents, do not rub the filter, and do not
wash in a dishwasher.
ATTENTION: Check the condition of filters
during cleaning. Replace filters when visi-
bly damaged.
To replace the top filter, remove the cover
from the filter (29)
Filters are sold at Polti authorized service cen-
tres and at www.polti.com.
7.3

CLEANING THE BRUSH

To clean the brush (25), proceed as follows:
- Move the locking cursor outwards (26) and
remove the roller lock (27).
- Remove the bristle cylinder (28).
Clean the brush
sure there is no dirt between the gears.
If there is, clean it with a fine tool and
check that the central pin is free to rotate.
- Replace everything by performing these
steps in reverse order.
bristle cylinder. Make
7.4 CLEANING THE MINI-TURBO BRUSH
(only for the Polti Forzaspira D-Power SR550
model)
To clean the mini-turbo brush, proceed as fol-
lows:
- Unscrew the mini-turbo brush.
- Remove the bristle cylinder.
- Clean the brush bristle cylinder.
- Replace everything by performing these
steps in reverse order.
8. STORAGE
8.1 Ensure that the appliance is switched off
and not charging.
8.2 Empty the dust collector tank.
8.3 When not using it for long periods, re-
move the battery.
14