Beper P205DIF050 Manual De Instrucciones página 8

Natural Salt Stone Aroma Diffuser Use Instructions
Operation
Remove all packaging materials and make sure all components are included in the box; keep packaging mate-
rials away from children and pets.
Remove upper unit (composed by upper cover, tank cover and water tank), and remove salt stones from the
container. Then lift the container up and install the lamp, by removing it from its package and inserting it inside
the housing found at the center of the base.
Replace the salt stone container, and fill it with salt stones, inserting one at a time to avoid damaging the
container.
Place the upper unit on top of the container with salt stones, making sure it is correctly installed.
If you wish to use mist function, remove upper cover and the water tank cover; fill with water making sure not
to go beyond the max level indicated. Add some drops of perfume or essential oil, and close the water tank
cover; replace the upper cover.
Insert the power cable inside the inlet found at the back of the base, and connect the plug to a wall socket. The
appliance will produce a short beep, and it will be ready for use.
To activate mist function, just press ON/OFF key once; to deactivate the function, press the key again.
Warning: the appliance is equipped with a safety system that automatically shuts the mist function
off when water runs out; if upon switching on or during operation of the appliance you hear a beep,
please checkt he water level inside the tank.
To activate light, press the activation and adjustment key until the desired level (5 levels available). To switch
the light off, press the key until the light goes out.
Cleaning and maintenance
Switch the appliance off and unplug it from wall socket.
After each use, empty the water tank and dry it thoroughly with a soft cloth.
Remove any stain or dust from outer surface with a soft cloth, slightly dampened with water if necessary.
Do not immerse the appliance in water or other liquids.
It is advisable to regularly clean the atomizer found inside the water tank, with a cotton swab or similar dampe-
ned with white vinegar, to remove any residue of limestone.
If the appliance is not used for long periods of time, empty out the water tank and dry it thoroughly, remove salt
stones from container and keep them in airtight containers/bags.
Warning: do not pour boiling or hot water inside the tank, high temperature may cause leakages
from the tanks.
To replace the lamp, remove it by gently pulling it upwards; replace it with a halogen lamp type G4, 10W max.
Technical data
Power: 18W
Adapter: Input AC 100-240V~ 50-60Hz - Output DC 24V === 0,75A
Lamp type G4 10W max
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8