BOCCHI 1075-0125 Serie Instrucciones De Instalación página 3

Monobloc Pedestal Installation
• Unpack the sink and inspect for defects. If you have any questions, contact BOCCHI immediately toll-free at
877-565-2221 or email BOCCHI directly at info@bocchiusa.com
• Temporarily set the sink into place on the floor.
• Draw a template around the footprint of the sink. NOTE: it is best
to draw this line with a temporary pen/pencil that will wipe off on
cleaning.
• Mark the positions of the installation holes on the floor.
• Mark the positions for the installation apparatus on both sides.
Leave a gap of 25mm inward from the edges. Place the apparatus
as shown in the diagram.
• Remove the sink and lay it carefully into its protective packaging
or onto a protected surface. NOTE: sink is breakable and should be
handled with caution to prevent damage.
• Pin down the installation apparatus on the floor with the screws.
NOTE: Make sure you are using the correct type of screws based on
your flooring. Consult a professional if you are unsure.
• The drain hole center should be approximately 130mm off-center
of the apparatus.
• Install the drainage pipe with one end to the sink, and the
other end to the hole in the floor.
• Place the sink into position.
www.BOCCHIUSA.com
3