Safety Instructions - Blumfeldt Hanami CW 180 Manual De Instrucciones

EN
10

SAFETY INSTRUCTIONS

• Remove the set from the box before connecting it to the power supply.
• Only use the power supply unit supplied. The unit is safe for both indoor
and outdoor use.
• Disconnect the mains plug when you are not using the LED tree.
• Do not expose the tree to direct heat or flames and do not immerse it in
water. The bulbs must not come into contact with flammable substances
or substances that melt easily.
• Avoid damage and rough handling of the cable sheathing and bulbs.
• Do not connect this set electrically to another set. Do not use the cable
if the sheathing is cut, frayed or otherwise damaged or if there are other
connections to exposed wires.
• Be careful not to damage the cable when passing it under a door or
window, especially if the door or window frame is made of metal.
• The LED bulbs cannot be replaced. Do not attempt to remove the LED
bulbs.
STRUCTURE AND OPERATION
Carefully remove the LED tree from the packaging and place the tree in an
upright position. Keep the box in good condition to store the tree in its original
packaging.
Fixing sleeves are included in the delivery, which you should use if the tree is to
be placed on topsoil.
• Secure the base plate with the screws.
• Insert the branches one after the other into the sleeves and screw the caps
tight.
• Plug together the cable connections that are on the branches. Make sure
that the male and female connections fit together.
• Connect the power supply unit to the connection cable.
Note: The power supply unit and the control unit may become warm during
normal use. Do not cover the ventilation openings or make access to them
difficult. If the mains cable is damaged, it cannot be replaced and the mains
unit must be disposed of.