Part List; Troubleshooting - Temper KEH-470 Manual De Instrucciones

KEH470
Hydraulic Crimping Tool
order to protect the environment please drain the waste oil to the
treatment center where was approved by government.

Troubleshooting

FAULT ANALYSIS
1. The pump lack
A. No pressure or
oil
the pressure is not
2. There
enough during
exist in oil
operation
3. Inner leakage
1. The tool can not
B. The lug and wire reach
do not connect rated pressure
tightly after crimping. 2. Use the wrong
die
C. Generate a lot of
1. Use the wrong die
burs after crimping
D. Oil leakage on the
1. Sealing kit broken
head or on the ram
SOLUTION
1. Fulfill or replace the
oil Change the oil
is dust 2. Contact
manufacturer
distributor
to the 1. Refer to the fault A
2. Replace with the
right die
1. Replace with the right
die
1. Contact manufacturer
or distributor and
replace it by trained
person

PART LIST

or
www.grupotemper.com