Troubleshooting Guide - Beper P202VAL200 Manual De Instrucciones

Rechargeable Floor Cleaner Use instructions
Trouble shooting guide
Problem
The product doesn't work
The roller doesn't work
Weak suction power
The product is leaking dust / water
The device makes strange sounds
Technical data
22.2V Lithium battery 2200 mAh
Power supply:
INPUT: 100-240VAC 50 / 60Hz 0.5A
OUTPUT: 27V DC 500mA
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Possible reason
Low battery
The roller is blocked
The dirty water container is full
The HEPA filter needs to be
replaced
The product needs to be rechar-
ged
The dirty water container is full
The HEPA filter is not properly
installed
The HEPA filter is perforated
Check if the roller or HEPA filter is
blocked due to large amounts of
dirt. Check if the dirty water tank
is full
16
Possible solution
Recharge the product
Remove the debris and if the
brush is blocked by filaments,
gently cut it with a scissor
Empty the tank
Replace the HEPA filter
Recharge the product
Empty the tank
Correctly install the HEPA filter
Replace the HEPA filter
Turn off the appliance. Clean the
filter and roller, empty the tank.