Charging & Operation - MH MOTORHEAD MH-03-JS-B1-0-1 Manual De Instrucciones

20V ULTRA Jig Saw 2Ah KIT (MH-03-JS-B1-0-1)
CHARGING & OPERATION
Charging The Battery Pack
Chargers are designed to use standard 120 volt AC, 60 Hz power. Do not use DC or any
other voltage.
BEFORE ATTEMPTING TO CHARGE YOUR BATTERY PACK, THOROUGHLY READ ALL
THE SAFETY INSTRUCTIONS.
• Batteries will reach full performance after about five charge/discharge cycles.
• The step of the battery pack has positive and negative terminal markings on it. Align
these with the identical markings on the top of the charging stand and insert pack into
base. (Pack will not insert properly if reversed)
• Normal charging time is 1 hour. The charger will charge the battery at the normal
charging is complete. After the battery is fully charged according to the charging time
provided in the instructions, remove the battery pack from the charging stand. Battery
temperature will cool to normal.
• When charging more than one battery pack, allow 15 minutes between charges.
• After many charge/discharge cycles, your battery will lose its ability to hold a charge.
It should then be replaced. Dispose of batteries at an appropriate waste disposal
facility. Do not throw batteries away in common trash receptacles.
• Place and charge the Battery Pack on a dry fireproof location in a room where the
temperature is from +39.2°F(4°C)-104°F(40°C).
• During charging the battery, the Battery Pack, Charger base, and Adapter may become
warm when you touch it. This is a normal condition, and does not indicate a problem.
• lf recharging a newly spent Battery pack, make sure it is undamaged and cool
completely.
• Always unplug the Charger when charging completed.
• Be sure the battery is cool before using it.
- Charging indications
Indicator lights
• Insert the switching adapter/plug into a 120V household current receptacle.
• The green light is the charge indicator. When the charger is connected to AC
household current, the green light is on.
• The red light is the power indicator. When the battery is properly inserted into the
charger and charging, the red light is on.
12
20V ULTRA Jig Saw 2Ah KIT (MH-03-JS-B1-0-1)
- Inserting and removing the battery
D
• To insert, simply push pack in until lock spring clicks.
• To remove battery pack from the tool, press the lock spring buttons (d in the functional
description) and pull out.
- Switch (C in the functional description)
• Make sure the battery pack is installed.
• To switch on, simply release the ON/OFF switch
trigger (C in the functional description).
• To operate continuously, press the lock-on button
(B in the functional description) after switching
on. The lock-on button can be release by pressing
the trigger again.
- Variable speed
• This tool has a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
• Speed is controlled by the amount of switch trigger depression.
- To install or remove the saw blade
WARNING: Before making any adjustments ensure the saw is
To avoid injury, if placing the blade, make sure the blade is
cool before touching it.
• Turn the Saw upside down, turn the Chuck clockwise and hold.
• Install the blade with teeth pointing towards front of Saw
• Release the Chuck to lock the blade.
WARNING! Before plugging in battery pack, always pull on
the blade to make sure it is securely locked in the clamp.
Failure to do so may result in serious injury.
13
B
C