Setting Something To Happen Every Day At The Same Time - Marmitek MT20 Mini Timer Modo De Empleo

To turn off ALL lights AND appliances connected to any kind of X-10 Module
(with the same Housecode as the Mini Timer), including Appliance Modules, press the
"All Off" button.

Setting something to happen every day at the same time

After you have installed all of your Modules and checked that they are working
instantly from the Mini Timer you are ready to program timed events.
1. Set the Mode Switch to the "Prog Set/Review" position.
2. Set the 1-4/5-8 switch as desired.
3. Press the "Time" advance rocker key to advance to the desired on or off time.
When you first press the rocker the time will advance by 1 minute. If you
hold the top of the rocker down the display will "speed up" so you can get
to the desired time faster. When you get close to the desired time, you can
"tap" the rocker a few times to get to the exact time you want. If you
overshoot, you can press the bottom of the rocker to go back.
4. When you reach the desired time press the ON or OFF button for the Unit
Code you want to program an On or Off
For example: If you advance to 12:45 PM and then press the ON button for number 2,
you will program the Module set to Unit Code 2 to go On at 12:45 PM every day.
If you advance to 7:00 AM and then press the OFF button for number 2, you will
program the Module set to Unit Code 2 to go Off at 7:00 AM every day.
You can now advance to another time and press another ON or OFF button (or the
same button) to program another time.
NOTE:
You can program a total of 64 On or Off times. These are distributed between the 8
unit codes (selected with the 4 ON/OFF buttons). You could for example program
Module number 1 to go On 32 times and Off 32 times, but then that would use up all
the memory and you wouldn't be able to program any times for any of the other 7
unit codes. Or, you could program modules 1 thru 8 to go On and Off 4 times each.
I.E. you could program 4 On and Off times for modules 1 thru 4, then slide the
selector switch to the 5-8 position and program another 4 On and Off times for
modules 5 thru 8.
MT20™
time for.
13