VONROC PR501AC Traducción Del Manual Original página 10

EN
Assembling and using the parallel guide (fig. C)
The parallel guide is a useful tool for precision
routing at a fixed distance from the edge of the
workpiece.
1. Fit the rods (8) to the parallel guide (11) using
the two bolts (12) provided.
2. Insert the bars (8) into the router base (9) as
shown on figure C.
3. Set the parallel guide to the required distance.
4. Tighten the Bolt for parallel guide (12).
Mounting the template guide (Fig. D)
The template guide is a handy aid for cutting
a pattern.
• Fit the template guide (25) to the base (9) of
the router, as shown on figure D. Be aware
to mount it with the flange to the bottom
(workpiece) side.
• Insert the two bolts (26) from the bottom side
through the template guide and tighten.
Mounting the vacuum cleaner attachment
(Fig. B+E)
The vacuum cleaner attachment (6) allows you to
connect a vacuum cleaner to the tool.
• Mount the vacuum cleaner attachment (6) to
the base (9) of the router, as shown on figure E.
• Insert the two bolts (26) from the bottom side
and tighten.
• Place the tube of your vacuum cleaner on the
vacuum cleaner attachment (6).
Note: keep the dust outlet on the rear side of the
machine to secure a good view on the workpiece.
Assembling and using the centre pin (Fig. F)
• To use the centre pin, insert one guide rod (8)
with the centre pin (27) attached into the holes,
either side of the base plate of the router.
• Secure the guide fence rod to the router at the
required length by rotating the fixing screw (12)
clockwise.
4. OPERATION
Let the tool work at its own pace. Do not
overload.
Carefully guide the cable in order to avoid
accidentally cutting it.
10
Switching the machine on/off (Fig. A)
• To start the machine, press and hold the lock-
off button (3) and press the on/off switch (21).
• To stop the machine, release the on/off switch
(21).
Speed Preselection (Fig. A)
The required speed can be preselected with the
speed adjustment wheel (17). Also during running
the rotational speed can be adjusted.
1 - 2 = low speed
3 - 4 = medium speed
5 = high speed
Max = maximum speed
The required speeds depends on the material and
can be determined by practical testing.
Furthermore router bits with a large diameter need
a lower rotational speed.
Material Diameter Router bit Speed stages
>20 mm
Hardwood 10 - 20 mm
<10 mm
>20 mm
Softwood 10 - 20 mm
<10 mm
>15 mm
Aluminium
>15 mm
>15 mm
Plastic
>15 mm
After longer periods of working at low speed, allow
the machine to cool down by running it for a few
minutes at high speed with no load.
Adjusting the depth of cut (fig. G, H)
The depth of cut is the distance between the depth
stop bar (18) and the depth stop revolver (13),
marked as 'X' on figure G. The depth of cut can be
set in two different ways as described as follows:
Adjusting the depth of cut using the scale (fig. G)
1. Fit the router bit as described above.
2. Loosen the knob for depth stop (15).
3. Pull the clamping lever (22) upwards, releasing
the router movement.
1 - 2
3 - 4
5 - max
1 - 3
3 - 5
5 - max
1
1 - 2
1 - 2
2 - 3
WWW.VONROC.COM