PRETUL DES-25P Manual página 7

Assembly
Shaft
• Align the safety pin (a) of the lower shaft with the
middle hole in the clamp (b).
• Press the safety pin down and insert the lower shaft into
the clamp.
• Release the safety pin; ensure that it engages in the hole
on the upper shaft .
• Tighten the locking knob clockwise to secure the
connection (c).
b
a
Anti-vibration Auxiliary Handle
• Install the auxiliary handle as shown in the figure.
• Move the auxiliary handle trough the string trimmer arm
to the right height to operate comfortably.
• Tighten the screws to fix the auxiliary handle into
position.
Cutting string replacement and mounting
• With the string trimmer off, remove the spool-retaining
cap (B) turning counter-clockwise.
• Remove the empty spool. Verify is clean and has no
damaged or worn parts.
• Cut one 5 m length of cutting string. Make a loop in the
middle of the line and insert the loop in the spool inner
hook (C). Hold the string and wind it clockwise.
Double-check is en of the string is wound in its respective
section (upper and lower). Do not wind too much string.
After wounding there shall remain a 6 mm minimum
distance between the spool edge and the wound string.
• Leave approximate 20 cm unwound centimeters on
both ends of the string and insert each one of them in the
spool notches (D). This is to prevent the string to unwind
while installing the spool in the string trimmer. Later on
you should release the strings from their notches.
• Set back the spool in its cover passing the ends of each
string through the cover orifices (E). If the string is loose or
tangled in this step, wind it again in the spool and secure it
in its notches.
• Set the spool cover in the axis (F) and secure the spool
tightening the retaining cap (B).
• Apply force and pull outwards both ends of the cutting
string to release it from the notches in the upper side of
the spool (G).
c
1
C
E
G
ENGLISH
2
F
D
B
7