Operation Of Sterimex; Control Panel; Ozone + Uv Program - THERMEx STERIMEX LARGE Manual De Instrucciones

M 710212200212052021

OPERATION OF STERIMEX

CONtROL PANEL

OZONE + UV PROGRAM

Always wait 10 min. from the end of
the program before the door is opened.
this allows Sterimex to purify the air of
various fumes and gases, as well as to
cool the cabin.
Power is used to turn Sterimex on and off.
Press Power to turn on the device. the control panel now lights up and the unit is in standby,
ready to start a cleaning program. If a program is not selected within 1 minute, the display
switches off again.
Press "Power" again to turn off the unit and interrupt the current cleaning program.
Ozone + UV is used to turn on the Ozone + UV purification program. the cleansing program
cleanses by a combination of Ozone and UV light.
Press Ozone + UV to set the Ozone + UV cleaning program. First press Ozone + UV selects the
program and the indicator starts flashing. It is now possible to set the timer for the program
by pressing time. When the time is set as desired, approx. 4 sec. without pressing the display
and the cleaning program starts. the flashing display becomes constant and confirms that
the cleaning program has started.
IMPORtANt! Do not open the door until 10 min. after completing the program.
During the cleaning process with the Ozone + UV program, ozone is released, which can be
harmful if inhalated. Never open the door while a program is running. Always wait at least
10 min. from the end of the program until the door is opened. this also applies even if the
program is interrupted on Power.
...
THERMEX StERIMEx LARGE
10 min.
47