Scott Living HDSLFP54W-4A Instrucciones De Montaje página 5

Assembly
1
Preparing top and partition panels assembly
NOTE: Do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all
bolts. This will make the assembly easier.
□
Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a carpeted floor
or the empty carton to avoid any scratches.
□
Securely screw the cam bolts (DD) into the designated small holes on the top panel (K) and partition panels (P and
Q) using a Phillips screwdriver.
2
Gluing wood dowels
NOTE:
Refer to the dowel guide drawings in this step for further clarification on how to properly glue in the wooden
dowels. Apply this method whenever instructed to install wood dowels
□
Glue the wood dowels (BB) into the designated holes on the panels (O, P, Q and R) and top front stretcher (W) as
shown. It is very important to use a small amount of glue on both ends of dowels and wipe away the excess glue
immediately.
O
P
K
R
BB
Q
BB
Q
P
.
W
BB
BB
BB
The dowel assembling
X
DD
BB
BB
FINAL
X