Cleaning And Maintenance; Problems And Solutions - Iseki PE500 Manual Del Usuario

PE500

5. CLEANING AND MAINTENANCE

• After each use, it is recommended to empty the tank completely. Add some clean
water and spray for 1 minute to clean the pump, pipes and nozzle.
• When you are not using the sprayer, place the lance in its housing, in an upright
position (9) (10).
• When you are not going to use the sprayer for a long period of time, you must store
it with a minimum of 60% charge (2 leds).
• To close the tank, place the lid matching both marks "
• Store sprayer under cover to avoid extreme temperatures.

6. PROBLEMS AND SOLUTIONS

PROBLEMS
No output pressure
The battery does not charge
Irregular spraying
12
POSSIBLE CAUSE
Dirty tank filter
Air in the hydraulic circuit
Damaged charger
or USB cable
Dirty nozzle
Damaged nozzle
www.iseki.fr
" and turn to the right (11).
SOLUTION
Clean the filter
Spray until all the air is
removed. It is recommended
to place the spray lance at a
level below the tank.
Change charger or USB Cable
Remove and clean nozzle
Replace the nozzle