ICQN MGA1-8 Serie Manual De Instrucciones página 17

Installation and Assembly Of The Oven
Operating space of the appliance shall be determined before starting
the installation.
Appliance shall not be installed on areas with high flow of air.
Handle the appliance with two persons at least. Do not drag the appliance
to prevent damage to the ground.
Remove all transportation materials inside and outside of the packaging.
Remove all materials and documents inside the product.
Installation Under Counter
Cabinet shall conform with dimensions specified in fig. 2.
A clearance with the dimensions specified in the figure shall be ensured
at the rear compartment of the cabinet to provide the required ventilation.
After installation, the clearance that shall be left between the bottom
of the counter and the top of the appliance is indicated by "A" in fig. 5.
This is for ventilation and it shall not be closed.
Installation In A High Cabinet
The cabinet shall comply with the dimensions given in fig. 4.
In the rear part of the cabin, and at the top and bottom, clearances with
the dimensions specified in the figure shall be ensured to provide the
required ventilation.
Installation Conditions
The dimensions of the appliance are given in figure 3.
The furniture surfaces to be installed and the installation materials to
be used shall resist a temperature of at least 100 °C.
To prevent the appliance from turning over, the cabinet to be installed
shall be fixed and the cabinet floor shall be level.
The floor of the cabinet shall be strong enough to withstand a load of at
least 60 kg.
Placing and Securing Of The Oven
Place the oven to the cabinet with two or more persons.
Make sure that the frame of the oven and the front of the furniture are
properly aligned.
The supply cord shall not be left under the oven or be stuck or bent
between the oven and the furniture.
17