Sharp DR-430 Manual Del Usuario página 9

Alarm functionality
Set an alarm
Note: Check that the radio is displaying the
correct time and date before you set an alarm.
Full Scan
Manual Tune
DAB+ DRC
Prune
System
Scan setting
FM AMS
System
BT System
Time
Duration
Source
Frequency
Volume level
Alarm
Note: If the time is not set or has failed to update
from the radio signal, <Time is not set> will be
displayed when you try to set the alarm. The radio
will then prompt you to set the time. An alarm can
only be set after the time has been set.
Stop, snooze or switching the
alarm off
To stop the alarm, short press
off> will be displayed. The alarm symbol will
remain in the display and will sound again at
the same time the next day unless it was set for
<Once>.
To snooze the alarm, press
displayed, followed by a 10-minute countdown.
Once the countdown ends, the alarm will sound
again. You can terminate snooze by pressing
<Alarm off> will be displayed.
System
Sleep
Alarm
Time
Backlight
Language
Factory reset
Software Version
Alarm 1 or 2 settings
Hour
Min
1, 5, 15, 30, or 60 minutes
Buzzer, DAB, or FM
Daily, once, weekdays or weekends
25%-100%
On or Off
,<Alarm
. <Snooze> will be
.
Alarm
Alarm 1 Setup
Alarm 2 Setup
To switch off the alarm, follow the steps for 'Set an
alarm' and select <Off>.
Sleep timer
You can set your radio to switch to standby mode
automatically using the sleep timer. You can
choose from <Sleep off>, <15>, <30>, <45>,
<60> and <90> minutes. To do this, long press
. Use to scroll and select <System>
/ <Sleep>. Use
preference. <Sleep> will be displayed. In the top
right of the radio display, the number of minutes
until your radio will switch to standby mode will
be displayed e.g., S90.
Display backlight timeout
To adjust the display backlight timeout, long
press . Use
<System> / <Backlight> / <Timeout>. Scroll
through the available backlight timeout options.
EN
to scroll and select your
to scroll to and select