Important Safety Instructions - Anker 531 Manual Del Usuario

Important Safety Instructions

• Avoid dropping.
• Do not disassemble.
• For the safest and fastest charge, use original or certified cables.
• Open flame sources, such as candles, must not be placed on this
product.
• Only use a dry cloth or brush to clean this product.
Notice
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation .
Warning :
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note :
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
(4) Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1-800-988-7973
03 EN
IC Statement
This device complies with Industry Canada license-ICES-003. Operation
is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This digital apparatus complies with CAN ICES-003(B) / NMB-003(B).
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2432
is in compliance with Directives 2014/35/EU & 2014/30/EU & 2011/65/
EU. The full text of the EU declaration of conformity is available at the
following internet address:
https://www.anker.com.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2432
is in compliance with Electrical Equipment (Safety) Regulations 2016
& Electromagnetic Compatibility Regulations 2016 & The Restriction of
the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012. The full text of the GB declaration of
conformity is available at the following internet address:
https://www.anker.com.
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon,
HongKong
The following importer is the responsible party (contract for EU and UK
matters)
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Limited, GNR8, 49 Clarendon Road, Watford,
Hertfordshire, WD17 1HP, United Kingdom
04 EN