Parts - Truper SOP-T12 Manual De Instrucciones

• The base must be fixed to a stable, solid, flat and level
workbench before starting up by means of four holes (I)
and four screws (not included).
CAUTION
To determine the location where the iron
base of the stand is to be mounted take the following
points into consideration:
• Make sure that a suitable power outlet is nearby.
• If the drill stand is to be permanently mounted on a
workbench, make sure the workbench is of adequate
height and is strong and stable enough to support the
weight of the drill, stand and workpiece.
• Take into account the length and width of the material to
be machined, make sure there is enough room at each
end and around the machine to accommodate the largest
piece of material to be machined safely.
• Mark the four mounting holes on the workbench surface
with a pencil.
• Remove the base and drill the four 3/8" (9.5 mm)
diameter holes at the marks made.
Depth indicator
6
ENGLISH
Adjustment knob
release button
Release
button
Walrus clamp
opening
control knob
Assembly
• Attach the base to the work base with 3/8"
(9.5 mm) diameter bolts, nuts and flat washers (not
included).
• Gradually tighten each bolt one at a time to seat
perfectly to the cabinet
base.

Parts

Control Depth
lever adjustment
knob
Clamp
adapter
Clamp
Clamp lock
Moving body
height locking device