Publicidad
Programming
Ensure the door is open before performing any programming.
The programming button is located on the interior chassis below the battery
holder (refer to page 17). During programming, if no button is pressed within 5
seconds, the system will time out and you will need to restart the procedure.
Add User Code
(UC)
Delete Individual
User Codes (UC)
Add/Change
Programming Code
(PC)
Delete all
User Codes
Enable/Disable
Audio
Enable/Disable
User Codes
Add One-time
User Code
Change Auto-Lock
Time Delay
Enable/Disable
Auto-Lock
Door Rehanding
Factory Reset
(lock must be in
unlocked position)
Programming
1
Button
Programming
2
Button
Programming
3
Button
Programming
4
Button
Programming
5
Button
Programming
6
Button
Programming
7
Button
Programming
8
Button
1
30 seconds
Programming
9
Button
Programming
0
Button
Press and HOLD Programming Button for 15 seconds
enter UC
enter UC
to delete
enter PC
4
enter one-time UC
press button for delay
2
3
1 minute
3 minutes
enter UC
to delete
4
5
5 minutes
10 minutes
Programming Button
again
19
Publicidad
