Safety Instructions; Installing The Product - nedis DEHU20WTW Guia De Inicio Rapido

r Ventilation mode indicator
LED
t Dehumidification mode
indicator LED
Continuous
y
dehumidification mode
indicator LED

Safety instructions

Icon Description
Indication to explain that the product:
Contains one or more (extremely/highly)
flammable components.
Indication to explain that the product:
Contains one or more (extremely/highly)
flammable components.
- WARNING
• Ensure you have fully read and understood the instructions in
this document before you install or use the product. Keep the
packaging and this document for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective. Replace
a damaged or defective product immediately.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified technician for
maintenance to reduce the risk of electric shock.
• Do not expose the product to water or moisture.
• Disconnect the product from the power source before service
and when replacing parts.
• If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
• Do not plug or unplug the power cable with wet hands.
• Do not use the product in dusty environments.
• Do not use near gas or other flammable materials.
• Do not spray the product with chemicals, acids, gasoline or oil.
• Do not place near other heat sources.
• Install the product in accordance with national wiring.
• Always check that the voltage of the product corresponds to the
mains voltage.
• Do not pull the power cord to shut down the heater, always use
the on/off switch.
• Do not use the product when the cable or plug is damaged.
• Make sure that the electrical supply in your area matches a
voltage of 220 – 240 VAC and a frequency of 50 Hz.
• Connect to a grounded socket only.
• If necessary, use an earthed extension cable of a suitable
diameter.
• Fully extend the power cord and make sure the power cord does
not contact the product.
• When using an extension cord, use one which is as short as
possible and fully extended.
• Do not let the power cable touch hot surfaces.
• Do not close a door on the power cable.
• Do not put any objects into openings. Do not use with any
opening blocked.
• Do not drink water from the product. This may cause illness.
• Do not use the product without the air inlet and outlet covers in
place to avoid touching hot and moving parts that may cause
injuries.
DEHU20WTW_DEHU30WTW_MAN_COMP_0522_ print.indd 5 DEHU20WTW_DEHU30WTW_MAN_COMP_0522_ print.indd 5
u Max+ dehumidification
mode indicator LED
i Dry laundry
dehumidification mode
indicator LED
Low fan speed indicator LED
o
Dehumidify mode button
p
On / standby button
a
• Be aware that the refrigerants should be odourless.
• The refrigerants should be added by the manufacturer, its service
agent or similar qualified persons.
• Do not use mechanical products or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.
• Do not use the product in temperatures below 0˚C.
• Do not sit on the product.
• Unplug the power cable when the product is not in use for a long
time.
• Do not block the air in- and outlets of the product.
• Some wireless products may interfere with implantable medical
devices and other medical equipment, such as pacemakers,
cochlear implants and hearing aids. Consult the manufacturer of
your medical equipment for more information.
• Do not use the product at locations where the use of wireless
devices is prohibited due to potential interference with other
electronic devices, which may cause safety hazards.
• Only install, operate and store the product in a room with a floor
area above 4 m
2 .
• Only store the product in a well-ventilated area.
• Do not use external timers or remote control systems to switch
the product on or off.
• Place the product in an area without any continuous sources of
ignition (for example: open flames, gas or electrical appliances in
operation).
• When the product is installed, operated or stored in a
non-ventilated area, make sure the room is designed to prevent
the accumulation of refrigerant leaks resulting in a risk of fire or
explosion due to ignition of the refrigerant caused by electric
heaters, stoves, or other sources of ignition.
• When defrosting and cleaning the product, do not use any
means other than those recommended by the manufacturing
company.
• Do not puncture or heat any part of the refrigerant circuit.

Installing the product

4 Make sure the product is placed on a flat and stable surface.
Keep a minimum of 300 mm of free space around the product.
4
Only move the product in an upright position.
4
This product might cause interference with nearby devices. To
4
avoid interference keep 700 mm distance between the product
and other devices.
Plug the power cable A
3 into a power outlet.
Assembling for continuous dehumidification
(optional)
1. Remove the water plug from the water hose connection A
2. Remove the water tank A 8
3. Place the water hose A 9 into A
4. Connect A 9 to a water container or drainage system (not
included).
Ensure that A is hanging down from A
9
4
cannot flow back into the product.
*Only for DEHU20WTW
**Only for DEHU30WTW
Installing the Nedis SmartLife app
1. Download the Nedis Smartlife app for Android or iOS on your
phone via Google Play or the Apple App Store.
2. Open the Nedis Smartlife app on your phone.
3. Create an account with your mobile phone number or your
e-mail address and tap Continue.
4. You will receive a verification code on your mobile phone or
e-mail address.
5. Enter the received verification code.
6. Create a password and tap Done.
5
.**
7
.*
7 .
7 , so that the water
23-5-2022 08:17:24 23-5-2022 08:17:24