DeLOCK 61858 Manual Del Usuario página 4

English
Hardware Installation
Note: If you use a new hard drive, please make sure that it is already formatted.
1. Connect your SATA drive to the docking cable.
2. Connect the power supply to the docking cable.
3. Now connect the power supply to the power outlet.
4.
Mount the cover plate onto your SATA hard drive and put it into the holder.
Driver Installation
1. Switch on your computer.
2. Connect the USB connector of the docking cable to an available USB port.
3. There is no driver required, so the device is ready to be used.
OTB Backup Software Installation
1. Switch on your computer.
2. Insert the backup software CD into your drive.
3. Open Windows Explorer, select: CD-drive\OneTouchBackup_ASMedia\
Setup.exe.
4.
Read the license agreement and confirm it by "I accept the terms in the
license agreement" and click on "Next".
5. Click on "Next", click on "Install".
6. Click on "Finish".
7. The software is now installed.
8.
After you have done all the setting on the software, you can press the
backup button now. A window will appear and the synchronization of the data
will start.
Support Delock
If you have further questions, please contact our customer support
support@delock.de
You can find current product information on our homepage: www.delock.com
Final clause
Information and data contained in this manual are subject to change without
notice in advance. Errors and misprints excepted.
Copyright
No part of this user manual may be reproduced, or transmitted for any purpose,
regardless in which way or by any means, electronically or mechanically, without
explicit written approval of Delock.
Edition: 02/2022
-4-