Cleaning, Care & Maintenance - NISBETS ESSENTIALS CT956 Manual De Instrucciones

EN
Overheat protection
This appliance is featured with an overheat
protection. Should the temperature exceed safe
levels the appliance will automatically cut off power.
The thermal Cut-out switch is located on the front
of the control unit. To reset the appliance after a
sufficient cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
Cleaning, Care &
Maintenance
• Always turn off and disconnect the appliance
from the power supply before cleaning.
• Always allow the appliance and oil to cool before
cleaning.
• Check the temperature with a suitable
probe thermometer; 40ºC is the MAXIMUM
temperature at which oil should be removed.
• For best performance, Nisbets Essentials
recommend that the appliance is cleaned after
each day of operation.
• Note: Failure to clean the appliance regularly
may result in premature activation of the
thermal cut-out switch.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not working
Oil spilling over
Unit slow to heat up
6
CT956_ML_A5_v3_20221123.indb 6 CT956_ML_A5_v3_20221123.indb 6
Probable Cause Solution
The unit is not switched Check the unit is plugged in correctly and switched on
on
Plug or lead is damaged Replace plug or lead
Fuse in the plug has Replace the plug fuse
blown
Mains power supply fault Check mains power supply
Too much food in the Remove some food
frying basket
Food is not dry Dry food before frying
Build-up of fat in the Clean the appliance
tank
Empty the oil tank
• Ensure to remove the frying basket first.
• Slowly rotate the control unit backward 90º until
it is locked vertically on the support brackets
of the tank holder. During this period, ensure to
hold the batter plate carefully.
• Let the oil accumulated on the batter plate and
heating elements recycle into the oil tank.
• Remove the batter plate, control unit and oil tank
consecutively.
• If the remaining oil is to be reused, then filtering
it before refilling will extend the oil's cooking life.
Clean all removable parts
• Use warm, soapy water and a soft brush to clean
the lid, basket, batter plate and oil tank.
• Dry thoroughly.
2022/11/23 17:19 2022/11/23 17:19