Tools Required - Garden Wood Furniture SIENNA 959KFSI Instrucciones Para Armar

ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver, Outdoor Wood Glue
FIG. 1
C
A
A
1) Glue three 10x40mm Wood Dowels (C) into the upper holes in the Left Leg Assembly (1)
and one 8x30mm Wood Dowel (D) in each end of Seat Brace (6) as shown in
FIGURE 1. Attach the Back (3), with the dowel hole in lower rail to the front, to the leg as-
sembly with two dowels and two Hex Bolts (A). Tighten bolts with the Hex Wrench (E).
Attach the Seat Brace (6), with the curved edge up, to the Back with the dowel and Screw
(B).
Attach the Front Apron (4) to the left leg assembly and Seat Brace (6) over the dowels and
fasten in place with Hex Bolt (A) and Screws (B).
Glue three 10x40mm Wood Dowels (C) into the upper holes in the Right Leg Assembly (2)
as shown in FIGURE 1. Attach the leg assembly to the front apron and back as before.
FIG. 2
2) Slip the Seat (5) down between the legs onto the seat brace. Attach to the leg assemblies
with Screws (B) through the two predrilled holes in each end of seat into the frame as shown
in FIGURE 2.
Insert a Screw (B) through each of the holes in the bottom of the center Seat Brace (6) into
the slats.
959KFSI Somerset Bench
D
B
C
A
A
C
C
D
B
C
B
B
BBBBB
A
A
C
E
A
959KFSI – Page 3