Battery Pack; Troubleshooting Guide - Metabo MA-HS 50 Manual Original

en ENGLISH
WARNING! No extension rod may be installed
between the cordless multifunction drive and
attachment.
Attach as shown in the operating instructions for the
cordless multifunction drive.
6.2

Battery pack

Read the operating instructions supplied with the
cordless multifunction drive.
7. Use
7.1 Adjust blade angle according to the
cutting application
WARNING! Remove battery pack. Attach the
protective sheath (3). Wear protective gloves.
See Fig. A, Page 2.
1. Push the locking lever (5) and keep pressed.
2. Change the angle between blade (2) and rod (6)
at the adjustment lever (4). Once the desired
blade angle has been set, release the locking
lever (5).
3. Move the adjustment lever (4) a bit to ensure that
the locking lever (5) has engaged and that the
blade (2) is locked securely in place.
7.2 Holding machine correctly,
Switching on and off
Before use, check that the adjustment lever (5)
has engaged and that the device is correctly
attached to the cordless multifunction drive (see
operating instructions of the cordless multifunction
drive).
The operator must keep good footing and hold
the machine firmly with both hands on the
handles. The blade (2) must not touch any objects
when the tool is switched on.
Do not switch on the motor, if the blade (2) is in
the folded transport position (see fig. below).
Before switching on, unfold the blade (see chapter
7.1). :
ON/OFF
Switch on and off as described in the operating
instructions for the cordless multifunction drive.
Have the machine repaired if braking time is
clearly lengthened.
7.3 Transporting
• Slide the protective sheath (3) onto the blades
(2).
• Bring blades (2) into the transport position, see
figure:
• Secure in a safe position for transport.
10
Do not switch on machine
in this transport position!
8. Cleaning
WARNING! Remove the battery packs .
Unintentional start-up can cause serious
injuries. The machine must be stationary. Wear
protective gloves.
Clean after each use: Remove dirt and other
deposits. Remove contamination, leaf debris etc.
(e.g. with a brush or cloth)
After cleaning: Treat cutting blade with Metabo
hedge trimmer care oil 6.30474 or Pump Spray
6.30475 (biologically degradable).
9. Maintenance
WARNING! Remove the battery packs .
Unintentional start-up can cause serious
injuries. The machine must be stationary. Wear
protective gloves.
9.1 Sharpen cutting blades
It is advisable to have blunt cutting blades
sharpened in a specialist workshop. Check cutting
blades regularly for damage and have them
repaired in a specialist workshop immediately if
necessary.
9.2 Lubrication
Every 40 operating hours, top-up grease through
the grease nipple on the gearbox housing using a
grease gun:
High temperature compound lithium grease
Upper grease nipple: 12 g
Lower grease nipple: 15 g

10. Troubleshooting Guide

When attaching to the cordless multidrive, the
rod ends cannot be pushed into each other.
- Read the operating instructions supplied with the
cordless multifunction drive.
f
11. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
A Cordless multifunction drive MA 36-18 LTX
BL Q, order no.: 601725850
B Hedge trimmer care oil (biologically
degradable), can (1 litre)
Order no.: 630475000
C Hedge trimmer care oil (biologically
degradable), pump spray can (0.3 litre)
Order no.: 630474000
For a complete range of accessories, see
www.metabo.com or the catalogue.