Protecting The Environment - Stanley 71501 Manual De Instrucciones Y Servicio

E N G L I S H
Assembly Instructions:
• Clean all the parts thoroughly. Inspect and replace any parts that are worn or damaged.
• Assembly is the reverse procedure for dismantling.
• Ensure that the seals (Items 4 & 5) and the wiper (Item 3), are replaced in the correct orientation. Lubricate all seals and
housings, with Molylithium Grease (07992-00020).
• When fitting the piston (Item 14) into the body (Item 13), it is essential that the assembly bullet 07900-00735 is used to
prevent seal damage.
• The jaw spreader housing assembly (Item 11) must be screwed onto the piston (Item 14) to a torque of 27 NM (20lbsf ft).
All item numbers refer to the General Assembly and Part List in section 6.0.

5.7 PROTECTING THE ENVIRONMENT

• Assure conformity with applicable disposal regulations. Dispose all waste products at an approved waste facility or site
so as not to expose personnel and the environment to hazards.
10
O R I G I N A L I N S T R U C T I O N