CRX CRX680 Manual Del Operador página 20

1. Place an appropriate
container below the oil drain
bolt. Remove the oil filler cap.
Next, using a wrench, loosen
the drain bolt counterclockwise.
Once loose, fully unthread the
bolt with your fingers removing
it and the bolt gasket.
2. When the oil is completely
drained, inspect the drain bolt
gasket for damage; replace if
required. Hand thread the drain
bolt. Using a wrench, tighten
until snug.
3. Ensuring the engine is on a
level surface, use the
recommended grade of oil to fill
the engine to the upper limit of
the dipstick. Do not overfill.
4. Return and tighten the oil fill
cap.
Promptly clean up any spilled oil
on the engine or the
surrounding area. Clean your
hands with soap and warm
water.
Only dispose of the waste oil at
a local waste oil recycler.
Oil fill cap
Replacing the oil filter
1. Using an oil filter removal
wrench, loosen the filter and
remove. Pour the oil contained
in the filter into the pan of waste
oil.
2. Clean any waste oil or debris
from the oil filter port. Using
fresh oil, lubricate the seal on
the new oil filter.
3. Tighten the filter by hand or
as per the filter instructions.
4. Ensuring the engine is on a
level surface, use the
recommended grade of oil to fill
the engine to the upper limit of
the dipstick. Do not overfill.
16-ENG