ACERBIS Reactive Manual De Instrucciones página 20

EN
HOW TO REMOVE
Remove the three screws and washers
on the face shield.
HOW TO REMOVE FROM THE BACK
Remove the back lining by pulling the
rear section to release the plastic
buttons.
HOW TO ASSEMBLE FROM THE FRONT
Insert the plastic part into the
designated slots along the plastic
frame.
19
6.1 FACE SHIELD INSTRUCTIONS
6.2 INNER LINING INSTRUCTIONS
HOW TO INSTALL
Place the face shield and secure it using
the screws and washers.
HOW TO REMOVE FROM THE FRONT
Remove the front by gently releasing
the inside along the frame. To facilitate
the operation, start from the side of the
frame.
HOW TO ASSEMBLE FROM THE BACK
on the back of the helmet fasten the
two plastic buttons.