Unpacking Instruction; Power Supply; Front Panel - Vonyx VMM301 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the equipment is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the equipment can be irreparably damaged. The equipment
must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.

FRONT PANEL

1. MIC/LINE & GUITAR INPUTS
Combo input jacks for mono signal (XLR microphones or
1/4" line input devices) or instruments such as an electric
guitar.
2. HI-Z
Switch to choose different input sources. Press to connect
with a high impedance audio source. When de-pressed,
XLR-microphone or low impedance audio device input is
selected.
3. CHANNEL 2 VOLUME CONTROL
Turn to adjust the volume for channel 2 (1). The led-
indicator lights up when the input signal is too high.
4. CHANNEL 1 VOLUME CONTROL
Turn to adjust the volume for channel 1 (1). The led-
indicator lights up when the input signal is too high.
5. MIC/LINE INPUT
When de-pressed (bounce up), stereo input is selected.
When both CH1 and CH2 are connected, they will
contribute to the stereo signal. When pressed, mono input
is selected.
6. PHANTOM SWITCH
Use to activate phantom power supply on the XLR
connector
(+48V phantom power).
7. MAIN VOLUME CONTROL
Turn to adjust the volume of the MAIN- (12) and USB
channel (13).
The led-indicator lights up when the input signal is too
high.
8. HEADPHONES VOLUME CONTROL
Turn to adjust the volume of the headphones channel.
9. AUX STEREO IN
3.5mm stereo jack AUX input for connecting a variety of external audio devices.
10. HEADPHONE JACK
6.35mm output jack, supporting stereo headphone plugs.
11. BT/USB SELECTOR
Change between BT and USB input.
12. STEREO OUTPUT (MAIN MIX)
Stereo 6.35mm output jacks. Connect with the input of an amplifier or a recorder.
4