Manual Defrost; Cleaning, Care & Maintenance - Polar GE580 Manual De Instrucciones

EN
Operation
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Turn the light switches On [I] or Off [O] as
desired.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The display
will flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance is noisy or Appliance is not level
works intermittently
The appliance is touching a
neighbouring object
Cooler cabinet is not Temperature set incorrectly
cold enough
External environment may
require colder temperature
The door is opened too often
Door seal is worn
Condensation Condensation may occur when the humidity is high and water particles in the air
contact with cold surfaces. This is normal, just wipe away with a dry cloth
4
GE580-GE581_GM813-GM814_ML_A5_v2_20221202.indb 4 GE580-GE581_GM813-GM814_ML_A5_v2_20221202.indb 4

Manual Defrost

The appliance will automatically run a defrost cycle
every 4 hours.
To manually defrost the appliance: Press and hold
the defrost button "
manual defrost. The defrost light illuminates.
Cleaning, Care &
Maintenance
•
•
•
•
•
Condensation and ice will form with frequent and
prolonged opening of the doors.
Operating outside of the recommend temperature
range and placing next to a heat source will also
buttons to display the
increase the amount of ice and condensation.
Excessive ice will result in longer running times
that will increase energy consumption and increase
the deterioration of components.
Probable Cause
Check unit is plugged in correctly and switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Check installation position and change if necessary
Check installation position and change if necessary
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Replace the seal
" for 2 seconds to begin a
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Always wipe dry after cleaning.
If left unused for any length of time, store the
appliance with the door ajar.
Solution
2022/12/2 16:31 2022/12/2 16:31