Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DW751/385103
5/2/02
12:51 PM
4. The Locator (Fig. 28)
The locator on the chuck of your drill bit sharpener has been
inspected at the factory for proper positioning and assembly. Should
the locator edge become damaged for any reason while grinding
during the initial learning operation of the tool, it is easily replaced
with the extra locator provided.
CAUTION: Tighten screws just enough to seat locator against
chuck. DO NOT OVERTIGHTEN
FIG. 28
CHUCK
Page 10
LOCATOR
SCREWS
10
Troubleshooting
PROBLEM
REMEDY
1. Chisel angle too great—
Bit was not ground close enough to
greater than 135°
locator or was positioned incorrectly, See
Step 6 under "Preparing to sharpen."
2. Chisel angle too small—
Edge of locator was not flat against flute.
less than 120°
See step 6 under "Preparing to sharpen."
Or bit was ground too close to locator.
3. Bit will not drill
Insufficient relief angle. See Step 6
under "Preparing to sharpen," for proper
positioning of bit.
4. Discoloration (burning)
Material is being removed too fast. Slow
near cutting lips
down feed rate.
5. Flats or chatter marks
A. Looseness in pivot rod bearing
on ground surfaces
system—see adjustments
B. Wheel needs dressing
C. Feed at slower rate
D. Slow down speed of rocking motion
6. Large variation in lip height
A. Bent bit
(point off center)
B. Looseness in pivot rod bearings—
follow adjustments
C. Unequal hand pressure on
swinghead while sharpening
Latch set screw needs adjustment.
7. Swinghead will not stay
locked in sharpening or
dressing position
Gib screws adjusted too tight.
8. Hard to pivot swinghead
back and forth
Place a 1/8" (3 mm) bit in chuck and
9. Bent locator
bend locator until the tip is directly over
bit center or replace locator.
Check motor air intake and exhaust
10. Unit getting unusually hot
openings on bottom of tool for blockage.
Publicidad
Tabla de contenido
