Tools required (not included): Phillips screwdriver, stud finder, measure tape, pencil, power drill and 1/8" drill bit.
37. Ask for assistance to position the assembled unit at the desired location against a wall.
38. In case of uneven floors, the Floor Levelers are provided at the bottom of Base Front Stretcher (J) for
the necessary adjustment. To adjust the unit, simply tilt the unit back and then adjust the floor levelers
by hand to correct tilting.
39. Now, follow the instructions printed on the plastic bag containing the Tipping Restraint Hardware to
attach the tip-over restraints to the unit and the wall.
NOTE: The tipping restraint hardware included is for wooden stud wall construction. It must be
attached to a wall stud. Depending upon your wall construction, different anchor hardware maybe
required. Please contact your local hardware store for assistance. Young children can be seriously
injured by tipping furniture. You must install the Tipping Restraint Hardware with the unit to
prevent the unit from tipping, causing any accidents or damage. The tipping restraints are intended
only as a deterrent, they are not a substitute for proper ad ult supervision. The tipping restraints are
not earthquake restraints. If you wish to add the extra security of earthquake restraints, they must be
purchased and installed separately.
40. The console is now ready for use.
Assembly Instructions
WARNING
Children have died from furniture tip-over.
To reduce the risk of furniture tip-over:
ALWAYS install tip-over restraint provided.
⚫
FOR use with televisions weighing 135 lbs (61.3 kg) or less. Use with heavier
⚫
televisions may result in instability causing tip-over resulting in death or
serious injury.
NEVER allow children to stand, climb or hang on drawers, doors, or shelves.
⚫
NEVER open more than one drawer at a time.
⚫
Place heaviest items in the lowest drawers.
⚫
Use of tip-over restraints may only reduce, but not eliminate, the risk of
tip-over.
22