Instruction Manual; Intended Use; Power Supply - Makita PC5010C Manual De Instrucciones

Ocultar thumbs Ver también para PC5010C:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Applicable cup-type diamond wheel Max. wheel diameter
Spindle thread
Max. spindle length
No load speed (n
) / Rated speed (n)
0
Overall length
Net weight
Safety class
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
Specifications may differ from country to country.
Weight according to EPTA-Procedure 01/2014
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Wear safety glasses.
Always operate with two hands.
DOUBLE INSULATION
Noise
The typical A-weighted noise level determined according to EN62841-2-3:
Model
PC5010C
NOTE: The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
M14 or 5/8" (country specific)
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.

Intended use

The tool is intended for planing concrete surfaces.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Sound pressure
Sound power level
level (L
) : (dB(A))
(L
pA
85
5 ENGLISH
PC5010C
125 mm
23 mm
-1
9,000 min
350 mm
2.7 kg
/II
Uncertainty (K) :
) : (dB(A))
(dB(A))
WA
96
3

Publicidad

Tabla de contenido
loading

Tabla de contenido